Redaction

Table 1. Redaction Parameters
Name	Values	Description
notext	false (default), true	Specifies that no transcript should be returned. Tip: To return just a scrubbed audio file, specify the following tags: output=text,notext=true,scrubaudio=true
scrubaudio	false (default), true	Supply the `scrubaudio=true` tag to apply the redaction feature to audio. When this option is specified, a zip file containing the redacted audio will return along with the transcript. Sections of audio where sensitive numbers are spoken are replaced with silence. See scrubtext for more information on what constitutes a sensitive number. Refer to scrubaudio for more information on this parameter.
scrubconf	scrubconf=</path/to/file	Used to specify JSON-formatted redaction scrubbing rules to override the default rules. See the scrubtext section for information about default scrubbing rules. Refer to scrubconf for more information on this parameter.
scrubmindist		Specifies the number of seconds within which two scrubbed audio sections will be merged when the `scrubaudio` tag is set to `true`. Defaults to 0.3. This is a fine-tuning parameter that rarely needs adjustment.
scrubsil	false (default), true	Pass the `scrubsil=true` tag to make redaction remove audio from regions where speech was not detected. This parameter only applies when `scrubaudio` is set to `true`. This setting increases security by blanking out audio that could contain sensitive information at a very low signal level, below the Voice Activity Detection (VAD) threshold.
scrubtext	false (default), true	Specify the `scrubtext=true` tag to apply Voci 's redaction feature to transcript text. Redaction recognizes and removes sensitive numeric values from results. By default, sensitive numbers are any string of numeric digits (as produced when `numtrans=true`) that do not fit into an “allowable” pattern. Refer to scrubtext for more information on this parameter.
scruboffset	integer (default 0)	Delay start of scrubbing until specified (N) seconds into audio. The scruboffset value is expected to be a non-negative integer. If it is not specified, the value defaults to 0, in which case the entire audio is available for scrubbing. This parameter is only available using V‑Blaze version 7.2+.